All of the products on this page can be ordered from Kiesub Electronics (702) 733-0024
LED Solutions
Order part number PCB08M04 for just the board stuffed and tested with programs installed
Order part number ASY08M04 for one in a box
A 3 or 4 point 12VDC 7.5 Amp per point LED animator.
DIP switch selects program patterns (click here for the PDF file showing pattern options) or custom programming available.
Figure each LED draws 20 mA. calculate 7.5 / .02 = approximately 375 LED's can be driven per point.
Blade type 7.5 Amp and 30 Amp fuses on board.
Each output has a over current detector that turns off the driver and protects it from damage.
Requires a regulated 12VDC power supply providing the necessary DC current for the amount of LED's you want to drive (not included).
p/n PCB08M04
Multi-Point LED drive solutions
The PCB08M12 board can drive 12 points of LED animation.
Each point is fused at 7.5 Amps DC.
Each point has over current protection.
Requires a regulated 12VDC power supply each 6 points to provide the necessary DC current for the amount of LED's you want to drive (not included).
Can be driven directly with any of ALDOR's sign controllers.
p/n PCB08M12 driven by ALDOR sign controller
Multi-Point EL drive solutions
We have been driving EL panels with triac boards for two years now.
The triac is nothing but a AC switch and the voltage to drive EL is usually 90VAC to 300VAC.
These voltages are well within the voltage range of our 600 volt triacs.
Each triac on the triac board can have it's own EL power supply or a power supply can be ganged to
multiple triacs depending on the power supply's square inch drive limitations.
The triacs on our triac boards can switch EL panels on and off with the addition of a EL power supply
Our small (p/n ASY3410T4) 3 or 4 point flasher can also drive EL with the addition of a single
EL power supply.
